How To Reset Username And Password On Uokoo Camera

How to reset IP Photographic camera to factory defaults

User Application Requirement

Updated 03-23-2015 09:45:xv AM 457292

This Commodity Applies to:

If you lot want to reset your IP Camera to factory defaults, yous can apply the following 3 methods. Subsequently resetting the device yous volition lose all your settings except Customer Settings.

Method ane ： Hard reset/ By pressing the RESET push

Step i

Go on the device powered on for at to the lowest degree thirty seconds to complete its normal startup.

Footstep two

Notice something like a pin to press theReset push button on the photographic camera and agree information technology for 15 seconds to restore the settings to mill defaults.

Step 3

After release Reset button, and the camera will exist restored to manufactory defaults after rebooting.

Note: Reboot procedure takes about i min, please be patient.

Method 2 ： By using Intelligent IP Installer

Step 1

Install the IntelligentIP Installer with the CD.

Pace 2

Run the Intelligent IP Installer. ClickSearch to find your device.

Step 3

Select your Camera inUPnP device list, clickManufacturing plant default on the right side.

Pace 4

Type the username and password in the login folio, the default username and password are bothadmin. Expect for the device to reboot.

If you changed the username and countersign before and forgot the username and password, you have to follow Method ane, make a difficult reset.

Note: Reboot process takes about one min, please be patient

Method iii ： Past using Spider web-based Utility (direction page)

Step i

Open the web browser and blazon the IP address of the IP Camera into the address bar, press Enter. If you accept changed the default port number is 80, Then type the IP accost of the camera: new port number into the address bar of spider web browser.

Footstep two

Type the username and password in the login page, the default username and password are both admin. And then click OK to connect to the device.

Step 3

ClickSETTING －＞BASIC－＞Initializeon the left side, and then clickManufacturing plant default to reset this IP Camera to the mill default settings.

Stride iv

Go along waiting until the progress bar shows completion.

Is this faq useful?

Your feedback helps improve this site.